List of Free Mods

[Toms95Formula]

Does anybody have a list of free mods or can tell me some that i can do. I would appreaciate it very much.

[Private Joker]

Throtle Body Bypass...
EGR Delete...
Thats about it on a LT1.
Best thing to do is if you have a single Cat car, put a cutout before the cat and run it at the track only. Best Bang for the Buck, besides juice! http://206.251.12.71/noncgi/smile.gif

[Toms95Formula]

How about juice could I blow up the engine

[Toms95Formula]

Do they make a system that won't blow if you miss a gear? I am interested but scared of doing some major damage!!!

[Euro749]

Tom,
Yes, you can setup your NOS system so it's very safe. But it will cost you more.

I have a fuel pressure switch, so the NOS shuts down if I don't have enough fuel flowing. MSD ignition that kills the spark if I hit the Rev. limiter. RPM activated switch, so the NOS only flows between the RPM range programmed and a TPIS switch witch only engages the NOS at Wide Open Throttle.

Almost forgot about the injectors. You need to get 24lbs SVO injectors because the stock ones tend to lock up at high RPM. (not good)

Hope that's safe enought.

-Darko

------------------
97 Z28 "ZYALATR" -- Fremont, CA
Black, M6, SLP 1 3/4, LT4KM, B&M Ripper, BBK 58mm TB, !TB, !Cats, HPP+, K&N FIPK, 160 stat, Mufflex 4", MSD6AL, Lou's Short Stick, March pulley, Perf. Friction Z rated, SS/BigBlock hood, ZR1 style 17x9, Panhard, LCAs, STB, Subframes, Street Twin. NOS
N20 12.2@116 1.98 60'
N/A 13.6@103 2.30 60'



[This message has been edited by Euro749 (edited 03-03-2001).]

[Toms95Formula]

Thanks i hope that it is safe enough. What could go wrong if i miss a gear? And about how much will it all cost?

[Private Joker]

For everything to be done safe and right, look at spending around $1000-$1200.
Mine was about that much and I have almost the same setup as Euro.
If you miss a shift on the juice and have it set up right... the juice will shut off at the point you tell it to... mine is 5900. My MSD Rev Limiter is as 6000 and the stock limiter is at 6200...
So the motor will rev up to 5900 REALLY FAST and then the juice turns off and the soft touch limiter kicks in... no harm done.
I have missed plenty of shifts and no probs! http://206.251.12.71/noncgi/smile.gif

[NoLimitsMotorsports]

You can use the MSD window switch also, it will only be on when you set it to be on (RPM wise).